Thingiverse
Mask Ear Refief
von Arhum92
7
Downloads
4
Likes
0
Makes
**I've added a version with no text on it as well**(4/15/2020)
*There is now a normal sized one and an elongated one for wider use*(4/14/2020)
This is a strap that you can print in PLA and it is thin enough to conform around the back of your head to latch onto surgical mask straps. This alleviates the constant pressure put onto the ears when wearing these surgical masks.
Make sure the printer bed is leveled properly because this is a thin print, the base is only 0.6mm thick.
This is very cheap and should be disposed with every used mask.
*There is now a normal sized one and an elongated one for wider use*(4/14/2020)
This is a strap that you can print in PLA and it is thin enough to conform around the back of your head to latch onto surgical mask straps. This alleviates the constant pressure put onto the ears when wearing these surgical masks.
Make sure the printer bed is leveled properly because this is a thin print, the base is only 0.6mm thick.
This is very cheap and should be disposed with every used mask.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
