Mask strap extender

There are two designs in this listing. One strap is 170 mm*15 mm. The shorter strap is 127 mm * 15 mm. It's thin, 1.2 mm which provides for some flexibility.

Print time is about 26 minutes at Low Quality .28 mm height and 3 grams of PLA.

This has been redesigned after feedback from hospital staff. The main problem with my prior design is the strap was not held tightly.

Here are the links to Tinkercad for each item:
Short strap - https://www.tinkercad.com/things/4juePoIlwjf
Long strap - https://www.tinkercad.com/things/lSHwcj4WCL5
Both Straps (Long and Short) - https://www.tinkercad.com/things/63oQ13Shfp5