Thingiverse
Mask Strap Narrow Stackable
von scottkarch
3
Downloads
0
Likes
0
Makes
This design is extremely flexible, uses less than 1M of filament per strap, strong enough and easy to stack ( it's so narrow on edge that there is very little attachment and the layered out put can snap off easily.
But, because it's almost 100% outer shell, my print speed really suffers. Would anyone like to test this design and help with settings that would allow fastest print speeds?
But, because it's almost 100% outer shell, my print speed really suffers. Would anyone like to test this design and help with settings that would allow fastest print speeds?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!