Thingiverse
Mask Strap Separator
von MaNwE
14
Downloads
10
Likes
0
Makes
VERSION V7 IS READY!!!!
I find this version the best to ware and to set up on head
Also easier to print. Because I add extra surface for better grip
OPASKA_V7_185X60mm.stl is for big boys ( higher and longer )
Best alternative I had found is this one
Just ....is less discrete :
https://www.thingiverse.com/thing:4674130
remix of drewlachlan design
___________________________________________________________________
This is what You need when You have pain behind your ears
from wearing mask longer than few hours
I designed this for my self and my colleagues at work
We have to wear mask 8 h per day.
I tested many other straps at thingiverse. but they do not spread band wide enough
All had some bigger or smaller flaws
After print cheek for any sharp edges at the inside of strep
You can smooth them out with lighter
Please post a make when You print one
I find this version the best to ware and to set up on head
Also easier to print. Because I add extra surface for better grip
OPASKA_V7_185X60mm.stl is for big boys ( higher and longer )
Best alternative I had found is this one
Just ....is less discrete :
https://www.thingiverse.com/thing:4674130
remix of drewlachlan design
___________________________________________________________________
This is what You need when You have pain behind your ears
from wearing mask longer than few hours
I designed this for my self and my colleagues at work
We have to wear mask 8 h per day.
I tested many other straps at thingiverse. but they do not spread band wide enough
All had some bigger or smaller flaws
After print cheek for any sharp edges at the inside of strep
You can smooth them out with lighter
Please post a make when You print one
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
