Mast Kit for Boats

Add some masts to your boat models. These are ideally suited for converting rowboats, ferries and dinghys into sailboats. Included is a range of masts, booms and mounts. Mix-and-match as required. The models are scaled about 1-in-10 and may be resized to suit your application.

When printing with a filament printer:
- Print only one mast/boom at a time. Multiple mounts are okay.
- Print with the mast/boom oriented upright.
- Use a brim for the mast/boom. Brim not required for the mounts.
- Make sure that you have good bed adhesion.
- Use a least 20% infill.
- No supports are required.

After printing:
- Clean up, prime and paint.
- Attach the mount to your boat using epoxy or other adhesive.
- Attach the boom to the mast.
- Make a sail from material or other thin stuff and attach it to your mast/boom.
- Insert the mast into the mount - use adhesive for a permanent joint.
- Add some rigging.

I really like the following watercraft models:
- OpenForge Dhingys by devonj