Thingiverse
Master spool (refill) from eono spool
von toastfr35
2
Downloads
2
Likes
1
Makes
This is a kit to convert a 'eono' filament spool to a refillable spool.
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle
You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.
2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.
No support needed.
Prints ok at 0.35mm layer with a 0.6mm nozzle
toastfr35 veröffentlicht auch auf
29 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!