Thingiverse
MATCH UP 8DSP (MK2) stand
0
Downloads
0
Likes
0
Makes
Stand to present the MATCH UP 8DSP (MK2).
The holder can be printed from any material. No supports are necessary when the model is placed on the build plate with the foot facing down. A layer height of approx. 0.15mm is recommended. By using threaded inerts for M3, it is possible to mount Magnets with a diameter of 17 mm and a height of 5.5 mm.
The holder can be printed from any material. No supports are necessary when the model is placed on the build plate with the foot facing down. A layer height of approx. 0.15mm is recommended. By using threaded inerts for M3, it is possible to mount Magnets with a diameter of 17 mm and a height of 5.5 mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!