Mavic 2 legs extension

# Introduction
I bring you the highly anticipated prolonged legs for Mavic 2!
Appearance has been designed for ease of use.
Legs does not affect sensor function. It is very lightweight and robust.

# Making
I recommend PLA material and 0.4mm extrusion nozzle.
You do not have to mirror the parts - each can be used for left of right side.
See attached printscreens - use some brim when you print front legs to get better adhesion!
After printing the front legs use sharp blade to clean-up the brim and the hole edges.

# Usage
The front legs are fastened by sliding to the stop.
Put rear legs on the thinner end of beam and then move towards the body of the drone.
Please see photos - rear legs needs to be attached in certain direction. The open side of the clip must point forward to the front of the aircraft and sit firmly!