Thingiverse
Max Angel Eye ringlight and mount
by W4YBO
24
Downloads
21
Likes
0
Makes
Designed for mounting and diffusing a 60mm "Angel Eyes" LED ringlight.
Mount the diffuser on the HE280 printhead using 3mm machine screws in the inside corner of the part cooling fans.
On the SeeMeCNC Rostock Max v3, pick 12v off the HE280 circuit board on either side of the screw opposite the heatsink cooling fan. !!! Be careful with polarity. It is marked !!!
Mount the diffuser on the HE280 printhead using 3mm machine screws in the inside corner of the part cooling fans.
On the SeeMeCNC Rostock Max v3, pick 12v off the HE280 circuit board on either side of the screw opposite the heatsink cooling fan. !!! Be careful with polarity. It is marked !!!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
