Thingiverse
Max Z Effector
von JAW
10
Downloads
7
Likes
0
Makes
After printing and studying this design, I would advise against using it. The cooling tube would interfere with the delta arms in some places, limiting the printable area of the printbed. Check out my new version here: https://www.thingiverse.com/thing:2376295.
This is a beta (which may be updated periodically) for an end effector that holds most of the hotend above the effector plane to give more z height and reduce slop from play in parallel arms. The part is designed for an E3D V6 Hotend and a 30mm cooling fan. The effector is also setup to receive a 5/16 o.d. (8mm) tube that will supply compressed air to blow on the filament (either via a blower fan or an aquarium air pump).
Print Settings: PETG
Sliced with CURA
Layer Height at .2mm
Supports: Yes
Brim: Yes
Actual pictures to come!
This is a beta (which may be updated periodically) for an end effector that holds most of the hotend above the effector plane to give more z height and reduce slop from play in parallel arms. The part is designed for an E3D V6 Hotend and a 30mm cooling fan. The effector is also setup to receive a 5/16 o.d. (8mm) tube that will supply compressed air to blow on the filament (either via a blower fan or an aquarium air pump).
Print Settings: PETG
Sliced with CURA
Layer Height at .2mm
Supports: Yes
Brim: Yes
Actual pictures to come!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
