MaxMicron Dual E3D_V6 Mount

Here is the Mount I've been using on My MaxMicron Aluminum Dual Extruder. I Made this Mount for using a BLTouch probe, but I Also added an Option for a 12mm inductive sensor. I'm Still looking for a good pin to use for the servo output on the OEM control board.

Below is a list of the Hardware that I Used.
three M3 x 12mm screws with standard Nuts for the clamp.
Two M3 X 8mm Screws with Lock nuts for the Air Ducts.
Two M3 X 24mm Screws With Lock nuts for the fans.
Four M3 X 12mm Screws with lock nuts for mounting to the carrage.
One M3 X 24mm Screw with Lock nuts for the Adjuster lock
One M3 X 5mm Screw for the Inductive sensor mount if you use it.