Maxtoch Xsword L2K lens protector/diffuser

This is a simple lens protector and diffuser for the Maxtoch Xsword L2k LEP flashlight (2021 red bezel edition). This cap has been designed to be approximately 2 mm wider internally than the diameter of the front of the flashlight. When printed out of PLA and annealed in boiling water, it should be a snug fit. If you do not plan on annealing, I recommend printing a few percent smaller or using electrical/painters/other tape along the inner edge of the side of the cap to reduce the inner diameter while providing a grippy surface for the flashlight to hold onto the cap.

The circular face of the cap should print as 2 layers thick at .3 mm high layers.