Thingiverse
MCC Steam Guard
by hubyamico
0
Downloads
3
Likes
0
Makes
Der Steamguard wird in dem Dampfgareinsatz eingesetzt und verhindert ein Zusetzen der Dampföffnungen.
Es wird empholen 2 Stück anzufertigen, damit er im Großen und kleinen Dampfgareinsatz verwendet werden kann
Bitte ausschließlich aus Lebenmittelechten und hitzebeständigem Filament drucken
The Steamguard is used in the steamer insert and prevents the steam openings from becoming blocked.
It is recommended to make 2 pieces so that it can be used in a large and small steamer insert
Please only print from food-safe and heat-resistant filament
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Es wird empholen 2 Stück anzufertigen, damit er im Großen und kleinen Dampfgareinsatz verwendet werden kann
Bitte ausschließlich aus Lebenmittelechten und hitzebeständigem Filament drucken
The Steamguard is used in the steamer insert and prevents the steam openings from becoming blocked.
It is recommended to make 2 pieces so that it can be used in a large and small steamer insert
Please only print from food-safe and heat-resistant filament
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
