Thingiverse
MDF crossbow Mount (wifi)
door Andrew_boulton
2
Downloads
2
Likes
0
Makes
This is a Mount for your MFD crossbow For the Gps and a Heltec esp32 Kit board. (others May work)
The gps uses a 12.7mm OD carbon tube and clips out the way for storage.
And using this mount you can take it off the tripod without the parts becoming lose as it doesn't use the 4-40 thread to hold the parts on.
it did take me a few attempts to make it print, and every printer will be slight diffent but i did mine flat down and 50% fill 0.2mm layers in ABS
The gps uses a 12.7mm OD carbon tube and clips out the way for storage.
And using this mount you can take it off the tripod without the parts becoming lose as it doesn't use the 4-40 thread to hold the parts on.
it did take me a few attempts to make it print, and every printer will be slight diffent but i did mine flat down and 50% fill 0.2mm layers in ABS
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!