Thingiverse
MeCreator2 - Cable Harness
by VisiTor
1
Downloads
0
Likes
0
Makes
MeCreator2 - Cable Harness
Well ... if you want to prevent your printer from looking like an orca with a "dorsal fin collapse", try these parts ...
Very easy to print.
Nice for beginners that just bought their "new-old" Geeetech on sale.
Glue back-pack parts (use pure acetone 95% ore more if you print ABS or cyanoacrylate glue if printed PLA, PETG)
"Rib-combination" at your covenience, where:
The big rib 'SG' supports the wire harness and
The small rib 'Sk' is for the PTFE tube(s)
Besides the prints you will need:
One or two pieces of PTFE tube, depending on your layout. One PTFE tube shoud be enough
Calbe ties
Screws and washers for the backplate: 2 x M3 16 mm fixing the backplate to the limit switch and 2 x M3 12 mm for the upper binding
Enjoy.
O.
Geeetech MeCreator2 Cable Harness
Geeetech MeCreator2 Wire Harness
Well ... if you want to prevent your printer from looking like an orca with a "dorsal fin collapse", try these parts ...
Very easy to print.
Nice for beginners that just bought their "new-old" Geeetech on sale.
Glue back-pack parts (use pure acetone 95% ore more if you print ABS or cyanoacrylate glue if printed PLA, PETG)
"Rib-combination" at your covenience, where:
The big rib 'SG' supports the wire harness and
The small rib 'Sk' is for the PTFE tube(s)
Besides the prints you will need:
One or two pieces of PTFE tube, depending on your layout. One PTFE tube shoud be enough
Calbe ties
Screws and washers for the backplate: 2 x M3 16 mm fixing the backplate to the limit switch and 2 x M3 12 mm for the upper binding
Enjoy.
O.
Geeetech MeCreator2 Cable Harness
Geeetech MeCreator2 Wire Harness
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!