Medal hanger

Printed at 20% infill but would recommend 25% to make the medal hanger arms a little more stiff when fully loaded. This fits on a Ender 3 no problem. I fused all the pieces together with a soldering iron and it works perfect. There is a couple small pieces that get printed because of where the middle split is but I only fused on the bigger one. Also, one of the pieces prints in two sections but it still fused great. It is also flat against the wall so I put small rubber washers under the mount holes to make it stand off the wall. This allows the medal straps to go on. Overall length is approximately 30" long and about 8' tall. I set my thickness to 1/2" (13mm).