Slicer Discord
MediBrace – Modelo 3D imprimible de Thingiverse Thingiverse

MediBrace

por juniortan
72 Descargas
137 Likes
0 Makes
Ver Modelo
Medical prototype. My kid was in a hospital recently, and they had to put him on an IV. The current practice here is to place a support _Under_ the wrist, tape everything up (for immobilization), and have the IV on top of the wrist. The problems we encountered were:

1. No protection for the top of the wrist where the IV was, causing much anxiety on my part on whether the dude was gonna knock his wrist against anything and dislodge the IV needle, etc (wince!)
2. Total lost of dexterity in the hands due to the support block

This prototype proposes to accomplish the following:

1. immobilization of the wrist from the top instead, secured by velcro bands (currently testing using velcro cable ties)
2. top of the wrist is protected by the Y arms of the brace, while still allowing the palm area to be secured by yet another velcro band
3. Fingers can still move (a lot more than before), without compromising the IV placement
4. A lot faster to deploy (dude had to change his dressing
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección