Slicer Discord
medication pump shower holder – 3D-Druckmodell von MakerWorld MakerWorld
Medical Tools

medication pump shower holder

0 Downloads
1 Likes
0 Makes
Zum Modell
This is way to take a shower while being hooked up to a pain pump, and having to keep the pump dry. Before I printed this, my wife would have to hold the pump just outside the shower curtain and I would still be on a short leash. Now with this dry box I bring the pump in the shower and do not have to worry about getting it wet. I place the pump in the bottom / inside box. The bottom box then slides inside the outer / top box and hangs from a very large lip. The pump is very secure on the lip, and most importantly it stays dry inside both boxes. With the pump in the box, there is plenty of room for the IV line to come out and hang down out of the box. I then bring the whole setup in the shower and hang it from the grab handle which gives me significantly more room to move around as long as I don't turn around all the way. If your shower does not have a hand rail, the dry box setup here can also be hung from the shower curtain rod.
Kategorie
Medical Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen