Meditate

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4This print uses 4 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Jade White At layer #15 (1.28mm) swap to Black At layer #17 (1.44mm) swap to Red for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!