Mega Legolike Pilgrim Hat

A Thanksgiving accessory for the 10:1 Mego Skeleton (and other 10:1 heads)PrintingI printed at .2 layer height with 8% gyroid infil. The tall part of the hat is hollow and tapers to a rounded cone to save filament and also avoid needing supports. The only supports needed are under the main opening that sits on the minifig's head. The slicer will try to add a support going up the center to the top but it's not needed so either lower your support threshold or just paint a support blocker inside the top of the hat. AssemblyThe buckle will press fit onto the belt but I glued it on as well. I didn't glue the belt onto the hat but you can.