Thingiverse
Megaconstrux Weapon Holder
par SUBMARINO_Design
7
Téléchargements
6
Likes
0
Makes
Weapon holder intended to be used with Mattel Megaconstrux figures, to hold weapons or other such accessories on the back.
Recommended that you print the holder flat on the print bed, with the taller side of the clamping section facing up for best strength. Printing standing up may cause the peg to break off in your figure, and is not recommended.
No supports required. Printing at 20% infill should take 1 minute to print each holder.
Recommended that you print the holder flat on the print bed, with the taller side of the clamping section facing up for best strength. Printing standing up may cause the peg to break off in your figure, and is not recommended.
No supports required. Printing at 20% infill should take 1 minute to print each holder.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
