Thingiverse
Megatron (Siege) Cannon
by J-zizzle
1
Downloads
2
Likes
0
Makes
I have a War for Cybertron Siege Megatron (WFC-S12). I was just having a little fun and decided to replace ol' Meg's cannon.
Basically just a slight redesign. I made the handle peg for the cannon separately. I find it adds strength that way. So, some superglue will be needed. It's just a bit larger than the stock cannon. Not too much. About the same circumference, but about 25% longer. (Now with 25% more blastin'!) Stock cannon is about 3 3/4" long. This cannon is 5" long. It's not so long that it drags on the ground. Mostly hollow, too, so it doesn't weigh down Meg's arm.
I print in PETG, slowly. It has some fine details, so you might want to crank the layer height down to 0.08.
Basically just a slight redesign. I made the handle peg for the cannon separately. I find it adds strength that way. So, some superglue will be needed. It's just a bit larger than the stock cannon. Not too much. About the same circumference, but about 25% longer. (Now with 25% more blastin'!) Stock cannon is about 3 3/4" long. This cannon is 5" long. It's not so long that it drags on the ground. Mostly hollow, too, so it doesn't weigh down Meg's arm.
I print in PETG, slowly. It has some fine details, so you might want to crank the layer height down to 0.08.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
