MakerWorld
Office
Go to Model
MEIJIA Hard Case Fidget Inserts
5
Downloads
4
Likes
1
Makes
These are inserts for the MEIJIA Hard Case. To fill the case you will need two end pieces, one center piece and then a total of 6 other rows (note that the double wide counts as 2 rows). To use, remove rippable foam from the case, but keep the bottom and topmost layers. Put these inserts in place of the rippable foam and let your spinners and sliders stick out the top of the holes so that the upper foam hold them in place. Make sure that the center row is in the correct place (it needs to be slightly smaller to accound for the screw that sticks into the case in the front. The case can be purchase on amazon here amazon found here: https://www.amazon.com/dp/B09V1459NV?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5&th=1
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!