Menina 800x fixed.

Diego's original files for the head did not print correctly when amplifying the statue. There was a small misalignment on the bottom and the hole for the neck which at least in my prusa resulted in the hotted to swirl to high above the bed. I did tinkercad the original file for the head to be completely flat by removing a small layer on the bottom to flatten it out. The head is now sized 800 times the original. It can actually be printed without supports.

In order to complete the statue you do need to print the original body scaled 800 times.
If you want to print it 1200 times than this head need to be at 150% (of course)
The fit is a bit tight and the neck and the hole are not completely round so be careful when joining them together. But in the end they do fit.

Thanks Diego for a lovely statue!!