Thingiverse
Menu Stand v2
door daniellindsley
5
Downloads
7
Likes
0
Makes
This is a simple stand for affixing menus. My use is for cocktail parties, but any 8"x11" paper should fit. Tape the backs of the corners to attach the paper.
The three pieces print flat (on a Lulzbot TAZ 6 bed) & then just require a couple dots of superglue to attach them.
The three pieces print flat (on a Lulzbot TAZ 6 bed) & then just require a couple dots of superglue to attach them.
daniellindsley publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
