Mercy Face Shield - Stackable

This is not really a remix but a stackable version of "Mercy Face Shield" by rkolibar.
All credits go to rkolibar, I just stacked them with a spacing of 0.3mm (double my layer height of 0.15mm) for easy separation.

You don't need supports as the little pieces (plastic sheet holders) print quite fine without, but enable them if you like as they don't need much time and material.
the 2-stacked-version needed ~1.75 hours (80mm/s) and the 4-stacked-version ~ 4 hours.

I printed with 20% infill and 100%. Both behave equal in bending, had nearly the same weight and 100% only needs some minutes longer to print. It's best to try it yourself.

Original thing by rkolibar:
https://www.thingiverse.com/thing:4259253