Merlin Garage Remote Replacement Case

My original Merlin garage remote case easily broke apart over time so I modelled this replacement. I will edit this description once I know what the exact remote model was. No screws are required but some sort of soft backing for the PCB will be needed where the buttons are to create a tight fit. I used a 2/3mm piece of rubber. Assembly instructions:Insert the green rubber button piece with the conductive pads into the X.Slide the PCB in over the top of the rubber piece.Slide in your piece of rubber (or similar) above the back of the PCB where the buttons are.Slide the back piece in, pressing down the rubber, so that it creates a firm fit. The back piece should not be loose afterwards.Add to your keyring to lock the back piece in place.