Thingiverse
Meshroom S GPU Extension
von SpaceM0nkey
1
Downloads
2
Likes
0
Makes
I created 2 adapters that offset the graphics card by 30mm so that it fits behind the motherboard using the standard mounting brackets. It is held in place by the 3D printed bar and also by 2 cable ties attached to the center panel.
To mount the GPU you will need some threaded inserts and a soldering iron as well as some screws.
Holes: 40x80mm
To mount the GPU you will need some threaded inserts and a soldering iron as well as some screws.
Holes: 40x80mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
