Thingiverse
MeshTastic / Meshcore 18650 box
von aman2454
1
Downloads
1
Likes
0
Makes
If you like this one, go check out my other one: https://www.thingiverse.com/thing:7290230
Simple box meant to mount to the antenna. In my case, the antenna is pole-mounted 8db antenna from Hexa Boost: https://www.amazon.com/Hexa-Boost-Antenna-Outdoor-Omni-Direction/dp/B0953Z1QF3
This means the meshtastic battery and device can function as a simple enclosure instead of a mounting facility, and affords much simplicity.
The antenna adapter is for the IPEX / IPX U.FL / UF.L -> N Type (N-type) SO-239 female connector.
The box is intended to give just enough room for your mesh radio plus 6x 18650 cells stacked. The intention is that the cells occupy the bottom half of the case, and the radio is above them.
There is no solid mount for the radio itself, so it is universal between Heltec / Rak / whatever - just make sure you wont short out on anything by using a piece of foam or cardboard to separate the battery pack and radio.
The cap is intended to be friction fit, but you may opt to
Simple box meant to mount to the antenna. In my case, the antenna is pole-mounted 8db antenna from Hexa Boost: https://www.amazon.com/Hexa-Boost-Antenna-Outdoor-Omni-Direction/dp/B0953Z1QF3
This means the meshtastic battery and device can function as a simple enclosure instead of a mounting facility, and affords much simplicity.
The antenna adapter is for the IPEX / IPX U.FL / UF.L -> N Type (N-type) SO-239 female connector.
The box is intended to give just enough room for your mesh radio plus 6x 18650 cells stacked. The intention is that the cells occupy the bottom half of the case, and the radio is above them.
There is no solid mount for the radio itself, so it is universal between Heltec / Rak / whatever - just make sure you wont short out on anything by using a piece of foam or cardboard to separate the battery pack and radio.
The cap is intended to be friction fit, but you may opt to
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
