Meta Knight

Just a model of Meta Knight that I made last year, I modelled him after how he looked in Super Smash Bros Brawl. It is about 3 inches tall (a bit shorter than a pop figure) and consists of four pieces. You will have to make the sword sit flat (because it is at an angle) to make it print properly. the pegs for the cape weren't connected to the cape when I printed it but I just glued it on without them and it sits fine. the pegs on the mask were a bit too big so I had to cut them down to size to fit in the holes I made. I personally found it printed better without the base and it stands on its own so I sliced it off but it's there if you want it.