Meteor65 Canopy Camera Mount Different Degrees

Hi guys,

this print is made by https://www.printables.com/@Slick1855_1031072
Original print at: https://www.printables.com/model/776782-meteor65-pro-15-degree-camera-mount

I have editted it in different degrees and just share it, all credits go to @Slick1855_1031072 . Thank you!

Print settings:
Support: Tree
Filament: Anything, TPU recommended, PLA or PETG can break easily on inserting the cam. ABS should work without break, but I don't know, I have no ABS ^^
Everything else should be just default of the filament. If it breaks on inserting try to pre heat it uppon inserting (PETG/PLA), TPU should bend a bit without problem.
It's a 10 minute print ;)

The original autor of this was not online for months, If I can change something for you, just write me or comment, I'm a noob but I try my best :)