Thingiverse
Metric Tap Guide
door sej7278
25
Downloads
13
Likes
0
Makes
Inspired by a video by clough42, I made a metric tap guide for M3.5-M12 taps.
Each tap hole was sized based on Little Machine Shop's clearance data plus a 0.2mm adjustment, plus or minus a fraction of a millimetre based on my printer's tolerances.
The smaller holes seemed to need more adjustment as they were tool small, but from M8 upwards they actually seemed too large! I've only test printed using PLA, so potentially with ABS shrinkage you may need further modification.
Fusion 360 file is included for remixing.
Each tap hole was sized based on Little Machine Shop's clearance data plus a 0.2mm adjustment, plus or minus a fraction of a millimetre based on my printer's tolerances.
The smaller holes seemed to need more adjustment as they were tool small, but from M8 upwards they actually seemed too large! I've only test printed using PLA, so potentially with ABS shrinkage you may need further modification.
Fusion 360 file is included for remixing.
sej7278 publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!