Thingiverse
MF07 Squonk mod DNA 75
door CalNatt
7
Downloads
15
Likes
0
Makes
READ ME FIRST!!!
Single 18650 battery squonk mod, DNA 75 board.
49.4 × 72 × 23mm no screws needed.
It doesn't work with stiff materials like ABS, PLA, etc.
Best printed in nylon, sls, ≤ 100μm resolution.
Be aware that if your print comes with attached spaces between the buttons on the front, you'll have to cut them. Same thing with the legs on both sides of the enclosure. Be careful when you cut, take your time as you can break the enclosure. Cutting those spaces is needed in order to make both buttons and legs used to hold the dna board in place, movable.
If you need to release the board from the enclosure, carefully lift the two legs from the inside and push the fire button so that the board will unlock.
What do you need:
-DNA 75 board
-510 squonk connector 22mm, m10 thread, 1mm thick. This one https://www.fasttech.com/p/9620834
-battery contacts
-wires as suggested here https://downloads.evolvapor.com/dna75.pdf even though I've used 18ga wire for all the wiring and it
Single 18650 battery squonk mod, DNA 75 board.
49.4 × 72 × 23mm no screws needed.
It doesn't work with stiff materials like ABS, PLA, etc.
Best printed in nylon, sls, ≤ 100μm resolution.
Be aware that if your print comes with attached spaces between the buttons on the front, you'll have to cut them. Same thing with the legs on both sides of the enclosure. Be careful when you cut, take your time as you can break the enclosure. Cutting those spaces is needed in order to make both buttons and legs used to hold the dna board in place, movable.
If you need to release the board from the enclosure, carefully lift the two legs from the inside and push the fire button so that the board will unlock.
What do you need:
-DNA 75 board
-510 squonk connector 22mm, m10 thread, 1mm thick. This one https://www.fasttech.com/p/9620834
-battery contacts
-wires as suggested here https://downloads.evolvapor.com/dna75.pdf even though I've used 18ga wire for all the wiring and it
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!