MFS Sovol SV08

Introduction:Meet the MFS (Manual Filament System) – an overhaul that enhances the versatility and security of your 3D printing setup. This remix replaces the traditional two-bearings approach with rollers connecting the bearings. This allows smaller spools to fit securely, eliminating the risk of them falling off the printer. Key Features:Versatile Rollers: Accommodate all spools, up to 75mm in width without needing adjustment. Filament Sensor Attachment: Easily clips to the center of the spool!Cable needs to be lenghtened so that the outer most spools can be reached!(the middle three work unlenghtend)Hardware Needed:Rods ca. 520mm long and 25mm in diameter (I used a expandable shower curtain rod wich I cut to length, they are really cheap)M3 screw and sleeve from the original assembly (m3x8mm)11 M5x12mm bolts (i used round heads but designed it for normal ones)10 M5 nuts.20 625ZZ ball bearings (same as the original creator used)4 M3 x 10 bolts4 heat-set inserts m3x4 to attach the MFS