MFT 20mm Hole plug

This is a plug to fill the holes of your MFT table when they are not being used. They are designed for holes that have been chamfered with the UJK or benchdog chamfer tools. These sit flush or just below the surface. I hot glue a Nut on the underside, so a magnet can be used to easily lift them out when you need to use the holes for clamping or for bench dogs.

Added a magnetic pick up tool to pop out the plugs from your table. Add two 10mmx5mm magnets. this can be stored in one of the holes near the edge of you table and you can pop it out and use to remove plugs with nuts glue to the bottoms.