MG-15 V2

A while back I made a model of the base weapon used to create the RT-97c blaster as seen in Star Wars: A New Hope (and many other places since!)

I was pretty new to OnShape / 3D modeling / printing, and did a lot of things differently than I would if I was starting the project today.

Since I needed to print one for myself, I decided to go back and make some improvements.

The big things that have changed:

- Parts are cut differently to make them easier to print with less support
- The barrel is hollow now, rather than solid with recesses
- It now requires a 1/2" dowel for the center of the barrel
- Overall improvements to the fit of the parts -- less sanding!
- The magazine is now angled instead of sitting flat

Still to do:
- Strap mounts for the top of the magazine
- Instructions!!!

Random notes:
- I printed the rear bakelite section in wood PLA, to try to emulate the look of the original material.
- Not sure how sturdy this will be... I don't recommend drop