MG Plus Basic Hot End for 3d Printers

This hotend is simplified, less expensive version of MG Plus hotend. It uses glue-on DIY modular thermistor, instead of ready to use screw-on M3 hex stud thermistor as in previously published MG Plus Hotend design.

Basic kit is available for 3.0mm filament and 1.75mm filament. Nozzle sizes available: 0.25, 0.35, 0.4, 0.5 and 0.6mm.

http://www.ebay.com/itm/221387332301
http://www.ebay.com/itm/221387359819

Assembly instructions and drawings
http://2x2.us/mg-plus-basic-assembly-instructions.pdf
http://2x2.us/mg-plus-basic-hotend-assembly.pdf
http://2x2.us/mg-plus-basic-heater-block-assembly.pdf