MG100 Warp Feeder

Tried to use the original Dye Dam warp feeder model, but couldn't import it properly in to my design software. Combined the warp feed design from the T15 tinkercad files to make a editable model. For some reason when starting with the Dye Dam version, Tinkercad would make a lot of holes in the model. When I combined the Dye Dam upper with the original bottom of the T15 tinkercad design, then I made a better version for the MG100. Extending the grooves for the magazine guide, rounding all the magazine corners, and trimming a little bit off of the areas I found needed to make the Dye Dam version fit in my MG100.

Future modifications will be to make a slit in the hopper tube and put in provisions for a fastener to allow some clamping rather than just a friction fit. I find that some loaders have slightly different tolerances and don't like to fit or are too loose.

Added V3 files for the bolt and nut. Some adjustment may be required to the hole to accept your loader. It is very