MGF Wind Deflector end Clips

These are the end clips (for want of a better description) that fit onto Wind Deflector of a soft top MGF.

One of my original clips was broken and I discovered that you I could only buy the complete wind deflector which given I had a 3D printer seemed to be a challenge I could not refuse.

I used the unbroken clip as a template to measure and draw a 3D version. Its not mm accurate but pretty close and does the job. Because the two ends are mirror image I copied and fliped the model to get both ends. I suggest replacing both ends at the same time as you will then have identical ends allowing for the tiny difference in the model to the original part. You can print them one at a time or I have added both on one file if your printer can manage it.

I was a little worried about strength and made the clip slightly thicker that the original cast metal piece but frankly it is so strong I suspect If you wished you could reduce the thickness back to the original. I printed in PLA