Miata / Mx5 TSI indicator

***Update - added a new much more streamlined version - 21/07/22***

My TSI design/work in progress that's based on the full Sketchup model of the mx5 by "The studeö".
Only part left to finish is the holes in for where the Screws go.

Designed it so that the bulbs from Moss fit -

https://www.moss-europe.co.uk/switchback-led-side-light-indicator-bulbs-glb382mx.html?fbclid=IwAR3TEQzVMbI2j1b5eYVvBXYJJVBnGLdBOZggeqGu41BVPXZ5ZUhTA5fwKh0

Should also fit any of the switchback LED bulbs like the bulb in the picture attached

The bulbs fit by being a tight snug fit on the rubber seal - could probably makes something to clamp it from behind if needed.
It doesn't line up 100% but tbh I think its good enough for a cheap easy TSI mod.
Print times at 0.25mm layer height is around 8 hours.
Anyone interested in the STL or any suggestions?

Supports are required! - I did mine at 55% overhang
Print with the Rear of the indicator flat to the bed.

Take 8 hours to print at 0.25 la