Thingiverse
Miata Speaker Grill
by GoobersWorld
31
Downloads
41
Likes
0
Makes
Steps to install part.
1. 3D print part and remove metal grill cover from panel.
2. Cut the inner ring where the metal grill slipped into.
3. Trim excess plastic.
4. Press and glue 3D printed grill into the plastic trim.
- Note: I found that I could hot glue the grill in place from the back of the panel while pushing down on the grill to seat properly.
1. 3D print part and remove metal grill cover from panel.
2. Cut the inner ring where the metal grill slipped into.
3. Trim excess plastic.
4. Press and glue 3D printed grill into the plastic trim.
- Note: I found that I could hot glue the grill in place from the back of the panel while pushing down on the grill to seat properly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
