Slicer Discord
Mic Amp MAX4466 Enclosure  – 3D-Druckmodell von Thingiverse Thingiverse

Mic Amp MAX4466 Enclosure

von jgutz20
25 Downloads
28 Likes
0 Makes
Zum Modell
a simple compact case for Max4466 breakout board/microphone. I'm using mine attached to a project box for a WLED Sound Reactive setup. The enclosure has 2 small pins to line up the circuit board and hold it in place, on the bottom is a “key” for the lid to help keep the bottom end secured. Underneath the lid, i made some space for the solder joints so the lid can sit flat on the case. I was able to just snap mine in place and its installed facing upside down and the lid stays in place, but you could put a couple drops of glue on this once you've made sure the device is working as expected and you're ready to mount it. I also included my test stl file, the one without mounting ears that you can just set wherever if attaching it to something else is not required. Also, i made this case deep enough so you can use breadboard jumpers on the header pins to keep it simple.

My ESP32 WLED SR case if you want to mount this microphone inside the ESP32 enclosure:

https://www.pri
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

jgutz20 veröffentlicht auch auf

8 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

3 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen