MakerWorld
Electronics
Zum Modell
mic stand remix
70
Downloads
36
Likes
33
Makes
Just another remix of STLsuppliers 100% 3d printed microphone stand. All I did was flatten the screws on either side so they'd be stonger and not slip or break like in the original. Im sure like a rubber washer could help as well but i havent tried. The holder piece has an inner diameter of 44mm and holds up a 200g mic better than before. Thanks for checking it out!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
