Micro Alien 3" Cinewhoop

# 2021 Update

I have updated ducts so they fit more snug now, there is about 0.5mm space between prop and the duct. The ducts are lower than the original.

There is also new GoPro 9 mount that goes over the top plate, screws are not required, but you can melt/drill some holes if you want to put screws for more security.

STLs are now run through Netfabb and are clean from any reported errors.

### Story

The journey with Cinewhoops started after watching NURK FPV videos with his Shendrone Squirt. I obviously seen a need for it and started to do some research about the Squirt. Quickly enough I found out that it’s not longer in stock, and shipping the frame from US would take ages, no one in UK stock them either…

So this is my version of a Cinewhoop based on the ImpulseRC Micro Alien FPV Frame 3”


### Build log

Build log and more info: https://tomt.co/cinewhoop

### Few notes

I left the under motor arms without holes in v.1, just so I could make needed ones my