Micro Chameleon

This is a 66mm Brushless frame based off of the chameleon. Uses 31mm props. This was designed around 0603 motors but I believe 0802 motors have the same motor pattern. You will also need 7 motor screws to hold the frame together and a drop of super glue wouldn't hurt. Camera space is up to 12mm so you need to use a small cam. Tolerances are tight and might need to do a little trimming depending on how dialed in your printer is. This was also designed with the motor connectors on the FC removed. However you can flip the FC upside down if you dont want to remove them. FC bushings need cut and half. Place half on the post then FC then the other half. I had to make the posts a little bigger so they dont snap when you put a screw in them.