Thingiverse
Micro Drone Frame with Canopy
von zzzNeRvT
6
Downloads
5
Likes
0
Makes
Hello,
with this two remixed Things i create my own Micro FPV Race/Freestyle Copter. Flys on 2S Lipo very well and its very lightwight. Print the Frame in PLA with 100 Infill and holes for a Lipostrap. For the Moment its strong enough and for the Canopy i use Resin.
Frame with holes for Motors is for Motors with 3 pin Connector. No solder needed.
For this Copter i use.
-BetaFPV 12A AIO Board 1-2S with ELRS Onboard
-Eachine Nano VTX (25-400Mw)
-Schubkraft 12000 KV Motor with 3 Pin Connector 1-3S
-2 blade Props 65mm with 1mm Hole
-Runcam Nano 2
-Tattu R-Line 550 mah 2S Lipo or Tattu 450mah 2S Lipo
with this two remixed Things i create my own Micro FPV Race/Freestyle Copter. Flys on 2S Lipo very well and its very lightwight. Print the Frame in PLA with 100 Infill and holes for a Lipostrap. For the Moment its strong enough and for the Canopy i use Resin.
Frame with holes for Motors is for Motors with 3 pin Connector. No solder needed.
For this Copter i use.
-BetaFPV 12A AIO Board 1-2S with ELRS Onboard
-Eachine Nano VTX (25-400Mw)
-Schubkraft 12000 KV Motor with 3 Pin Connector 1-3S
-2 blade Props 65mm with 1mm Hole
-Runcam Nano 2
-Tattu R-Line 550 mah 2S Lipo or Tattu 450mah 2S Lipo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!