Thingiverse
Micro Extruder movement indicator
door APuckNut
4
Downloads
4
Likes
0
Makes
I didn't like the larger designs for the inidicators and wanted something that did the job but in a discreet way.
You'll need a single 8x3mm Neodymium Magnet and some super glue.
On the top surface there is a 0.5mm raised piece. I did this to enable easy removal and ensure the indicator was not flush against the motor body. Glue the magnet to this top piece with a small (!) drop of superglue.
Hope you enjoy. Please post a picture if you print one.
You'll need a single 8x3mm Neodymium Magnet and some super glue.
On the top surface there is a 0.5mm raised piece. I did this to enable easy removal and ensure the indicator was not flush against the motor body. Glue the magnet to this top piece with a small (!) drop of superglue.
Hope you enjoy. Please post a picture if you print one.
APuckNut publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
