Micro Lathe Frame

NEW UPDATE: 1/5/2016

Beta 1.2

I've updated the Tool Holder, so if you print it off, the cutting edge of your tool should actually be lined up with the center of the part you're turning.

This isn't entirely true though, it's intentionally a little low, so you'll probably have to shim it up just a tad. It's just easier to shim the tool up versus the post being too high and being unable to shim it down in this current design.

I haven't the time to test it all myself, but unless my math is wrong this whole thing should be good to go.

Let me know if it works for you!

P.s. I also made the angle increments a little larger to the print a bit clearer.



UPDATE: 12/9/15

Beta 1.1 of my Micro Lathe Frame.

I can now recommend printing everything except the Tool Holder, top and bottom. These will be updated shortly.

In order to give chuck jaws reasonable clearance, the default Headstock height has been changed to 175mm. The Tailstock centering has been changed accordi