Thingiverse
Micro-Minion Shroud
von Slake1
1
Downloads
1
Likes
0
Makes
Remix of the eB Fan Shroud using a 30x30x10 radial fan.
Can be used for the Creality Carriage, even though it is mounted on a Ender belt kit as in the photo.
Radial Fan Screw holes are a bit big so it is recommended to tighten with nuts. Screw is M3.
Blower has holes for M2 screws which are loose, but the Radial Fan does press on the blower fan when mounted. It is always recommended to use screws. Have fun printing!
Can be used for the Creality Carriage, even though it is mounted on a Ender belt kit as in the photo.
Radial Fan Screw holes are a bit big so it is recommended to tighten with nuts. Screw is M3.
Blower has holes for M2 screws which are loose, but the Radial Fan does press on the blower fan when mounted. It is always recommended to use screws. Have fun printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
