Thingiverse
Micro SD Card Box
von davidkerton
12
Downloads
4
Likes
0
Makes
I printed the original and found that the SD cards don't sit further in the case as the pictures showed., as a result, the lid ended up snapping an SD card when screwed on.
As a result, I remixed the lit to increase the height between the SD card and the lid and also added a centre ring so that the lid screws onto that keeping a good height with the SD card.
20% infill
Supports not needed
V3 Lid added - Internal ring resized to match ring on bottom half of box.
As a result, I remixed the lit to increase the height between the SD card and the lid and also added a centre ring so that the lid screws onto that keeping a good height with the SD card.
20% infill
Supports not needed
V3 Lid added - Internal ring resized to match ring on bottom half of box.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
